Connecting The Door Station - SOMFY V100 Notice D'installation Et D'utilisation

EN

5.1 Connecting the door station

5.1.1 To a Somfy gate motorisation
Note: When the motorisation is solar-powered, the wired controls are deactivated. In this case, you must use the monitor's wireless control to control
your gate motorisation (see page 17).
[1]. Disconnect the motor from the mains power supply.
[2]. Remove the cover from the control cabinet or from the motor containing the electronics.
[3]. On motorisations equipped with electronics represented in the view on the le , connect the dry contact output (COM and NO) on the
door station to terminals 3 and 4 (yellow "BUS" label) on the motorisation electronics.
On motorisations equipped with electronics represented in the view on the right, connect the dry contact output (COM and NO) on the door station to
terminals 5 and 3 on the motorisation control box to open the main gate or to terminals 6 and 3 to open the pedestrian gate.
Door station
Connect...
COM
NO
Note: To connect the door station to another brand of gate motorisation, please refer to the installation guide for that motorisation.
5.1.2 To a door-opener/electric lock
Connect the door station output
station to the door-opener/lock in accordance with the
diagram below.
Observe the +/- polarity if indicated in the door-
opener/lock instructions.
9
to the START termi-
nals
5
6
on the door
* not provided
Somfy motorisations electronics
to the BUS termi-
nals
3
4
Video door phone V100
to the numbered terminals
3
5 (for complete opening)
or
6 (for pedestrian opening)
*
800 mA max
Copyright © 2018 SOMFY ACTIVITES SA. All rights reserved.