Programming A Somfy Rts Garage Door Motor; Programming A Somfy Rts Lighting Receiver - SOMFY VSYSTEMPRO Origin RTS Manuel D'utilisation

EN

3.3 Programming a Somfy RTS garage door motor

[1]. Open the motor cover.
[2]. Check that the motor is powered on.
[3]. Select the channel by pressing the channel selection button on the monitor.
[4]. Press the settings button
- The motor settings indicator light comes on and stays on.
[5]. Briefly press the monitor opening button.
- The motor settings indicator light flashes then goes off.
[3]
1..2..3..4..5
Note: To clear the programming on the video entry phone on a Somfy garage door motorisation, repeat all the steps detailed
above.

3.4 Programming a Somfy RTS lighting receiver

On a Somfy RTS remote control terminal or socket
[1]. Remove the monitor from its rear section (see 3.1 General information, page 5).
[2]. Check that the remote control socket/plug is switched on.
[3]. Select the second channel by pressing the channel selection button on the monitor.
[4]. Press the programming button on the remote control lamp holder/socket until the indicator light flashes.
[5]. Briefly press the PROG button at the back of the monitor (above the battery housing).
- The indicator light on the remote control socket/plug will come on permanently, then go off.
[2]
1..2..3..4..5
[6]. Return the monitor to its rear section (see 3.1 General information, page 5).
Note: To clear the programming on the video entry phone on a Somfy garage door motorisation, repeat all the steps detailed
above.
On a Somfy RTS light receiver
Caution: The receiver uses a 230V power supply. Do not touch the terminal or the bare wires.
[1]. Remove the monitor from its rear section (see 3.1 General information, page 5).
[2]. Open the light receiver.
[3]. Check that the receiver is powered on.
[4]. Press the PROG button on the receiver until the indicator light on the receiver comes on.
- The programming function is activated for 2 minutes.
[5]. Select the channel by pressing the channel selection button on the monitor.
7
on the motor and hold down for 3 seconds.
[4]
3s
[3]
2s
2s
Examples of Somfy remote control sockets and plugs
[5]
<0,5s
[4]
2s
Copyright © 2016 Somfy SAS. All rights reserved.