Emergency Off; Heater Coil Error; Power Supply Failure; Hst300 Pricon+ Technical Specifications - Hürner HST 300 Pricon+ Manuel De L'utilisateur

the upper limit depends on the load value and is calculated as the cur-
rent at start plus 15%.

11.2.7 Emergency Off

The welding process has been interrupted by pressing the STOP/RESET
key.

11.2.8 Heater Coil Error

The current value during welding differs by more than 15% from the
nominal value, indicating a short-circuit in the heater coil.

11.2.10 Power Supply Failure

The last welding is incomplete. The welding device was disconnected
from power supply voltage.
12

HST300 Pricon+ Technical Specifications

Nominal Voltage
Frequency
Power
Protection Index
Primary Current
Ambient Temperature
Output Voltage
Max. Output Current
Memory for Reporting Protocols
Tolerances:
Temperature
Voltage
Current
Resistance
USB A Interface (at the front of the unit)
for connecting USB printers and USB mass storage media (such as
a USB stick)
USB B Interface (at the back of the unit)
for connecting the welding unit directly to a PC
Both interfaces comply with the USB version 1.1 specification (i.e., maxi-
mum data rate of 12 megabits per second).
To work properly, the used printer has to support PCL (Printer
Command Language). Please refer to the manual of your
printer for more information. A list of supported printer makes
Important
is also available from Hürner Schweisstechnik on-line at
www.huerner.de
13

Service and Repair Contact

Hürner Schweisstechnik
Nieder-Ohmener Str.
35325 Mücke, Germany
Web: www.huerner.de
We reserve the right to change technical specs of the unit
without prior notice.
Info
20
EN
All manuals and user guides at all-guides.com
230 V
50 Hz - 60 Hz
2800 VA, 80 % ED
IP 54
16 A
- 20 °C to + 60 °C
8 V - 48 V
110 A
2000 reports
± 5 %
± 2 %
± 2 %
± 5 %
Tel.: +49 (0)6401 9127 0
Fax: +49 (0)6401 9127 39
E-mail: info@huerner.de
HST300 Pricon+ User's Manual
H Ü R N E R S c h w e i s s t e c h n i k G m b H
Nieder-Ohmener Str.
35325 Mücke, Germany
Version January 2009