Introduction; Safety Messages; Using The Correct Connection Terminal; Improper Use Of The Welding And Power Supply Cables - Hürner HST 300 Pricon+ Manuel De L'utilisateur

Poste de soudage universel avec traitement de géo-infos avec interface usb
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

H Ü R N E R S c h w e i s s t e c h n i k G m b H
Nieder-Ohmener Str.
35325 Mücke, Germany
1

Introduction

Dear Customer:
Thank you very much for purchasing our product. We are confident that
it will meet your expectations.
The HST300 Pricon+ Welding Unit is designed exclusively for welding
electrofusion fittings made of plastic.
The HST300 Pricon+ was manufactured and checked according to state-
of-the-art technology and widely recognized safety regulations and is
equipped with the appropriate safety features.
Before shipment, it was checked for operation reliability and safety. In
the event of errors of handling or misuse, however, the following may be
exposed to hazards:
the operator's health,
the HST300 Pricon+ and other hardware of the operator,
the efficient work of the HST 300 Pricon+.
All persons involved in the installation, operation, maintenance, and
service of the HST300 Pricon+ have to
be properly qualified,
operate the HST300 Pricon+ only when observed,
read carefully and conform to the User's Manual before working with
the welding unit.
Thank you.
2

Safety Messages

2.1

Using the Correct Connection Terminal

Use the appropriate connection terminal that is compatible with the fit-
ting type used. Be sure the contact is firmly established and do not use
burnt connection terminals or terminal adapters that are not designed
for the intended use.
2.2

Improper Use of the Welding and Power Supply Cables

Do not carry the HST300 Pricon+ by its cord and do not pull the cord to
unplug the unit from the socket. Protect the cables from heat, oil, and
cutting edges.
2.3

Securing the Fitting and the Joint

Use clamps or a vice to secure the fitting and the joint to be made
before welding. The fitting manufacturer's installation instructions, DVGW,
DVS, European and national regulations will have to be respected in all
cases.
The welding procedure for a fitting must never be repeated, since this
may cause parts under power to be accessible to the touch.
2.4

Cleaning the Welding Unit

The HST300 Pricon+ must not be sprayed with or immersed in water.
Version January 2009
All manuals and user guides at all-guides.com
HST300 Pricon+ User's Manual
5
EN

Publicité

Table des Matières
loading

Table des Matières