Omron V1000 Guide De Démarrage Rapide page 26

Par. Name
0:Disabled - Motor stall or
Stall Prev.
overload might occur.
L3-05 Selection
1:Decel Time 1 - Reduce speed
during Run
using C1-02.
Stall Prev. Sets the current level at which
L3-06 Level dur- stall prevention during run starts
ing Run to operate.
Auto-Tuning
0:Rotational Auto-Tuning
Auto-Tun-
2: Terminal resistance only
T1-01 ing Mode
3: Rotational Auto-Tuning for
Selection
Energy Saving
Rated Sets the motor rated power
T1-02
Power (kW).
Rated Sets the motor rated voltage
T1-03
Voltage (V).
Rated
T1-04 Sets the motor rated current (A).
Current
Base Sets the motor base frequency
T1-05
Frequency (Hz).
Motor
T1-06 Sets the number of motor poles.
Poles
Base Sets the motor base speed
T1-07
Speed (RPM).
Iron loss for determining the
Motor Iron
T1-11 Energy Saving coefficient.
Loss
If unknown leave it on default.
Monitor
U1-01 Frequency Reference (Hz)
U1-02 Output Frequency (Hz)
U1-03 Output Current (A)
U1-05 Motor Speed (Hz)
U1-06 Output Voltage Reference (Vac)
U1-07 DC Bus Voltage (Vdc)
U1-08 Output Power (kW)
Torque Reference (% of motor rated
U1-09
torque)
I67E-EN V1000 Quick Start Guide
AUDIN - 8, avenue de la malle - 51370 Saint Brice Courcelles
Tel : 03.26.04.20.21 - Fax : 03.26.04.28.20 - Web : http: www.audin.fr - Email : info@audin.fr
Description
Description
6 Parameter Table
Monitor
Input Terminal Status
U1-10 = 0 0 0 0 0 0 0
U1-10
Output Terminal Status
U1-11 = 0 0 0
1: Relay Output
(terminal MA-MC closed
U1-11
1: Open Collector Output 1
(terminal P1) enabled
1: Open collector Output 2
(terminal P2) enabled
Drive Status
U1-12 = 0 0 0 0 0 0 0 0
U1-12
U1-13 Terminal A1 input level
U1-14 Terminal A2 input level
Soft Starter Output (fref after accel./decel.
U1-16
ramps)
U1-18 OPE Fault Parameter
U1-24 Pulse Input frequency
Description
1: Digital input 1
(terminal S1 enabled)
1: Digital Input 2
(terminal S2 enabled)
1: Digital Input 3
(terminal S3 enabled)
1: Digital Input 4
(terminal S4 enabled)
1: Digital Input 5
(terminal S5 enabled)
1: Digital Input 6
(terminal S6 enabled)
1: Digital Input 7
(terminal S7 enabled)
MB-MC open)
1: During run
1: During zero-speed
1: During REV
1: During fault reset
signal input
1: During speed agree
1: Drive ready
1: During alarm
detection
1: During fault
detection
25