Omron V1000 Guide De Démarrage Rapide page 16

4 Keypad Operation
LED Operator and Keys
The LED operator is used to program the drive, to
start/stop it, and to display fault information. The
LEDs indicate the drive status.
Keys and Functions
Display Name
Data
Area
ESC Key
RESET Key
RUN Key
RUN
Up Arrow Key
Down Arrow Key Scrolls down to select parameter numbers, setting values, etc.
STOP Key
STOP
ENTER Key
LO/RE Selection
Key
ALM
ALM LED Light
REV
REV LED Light
DRV
DRV LED Light
FOUT
FOUT LED Light
I67E-EN V1000 Quick Start Guide
AUDIN - 8, avenue de la malle - 51370 Saint Brice Courcelles
Tel : 03.26.04.20.21 - Fax : 03.26.04.28.20 - Web : http: www.audin.fr - Email : info@audin.fr
Display
Displays the frequency reference, parameter number, etc.
Returns to the previous menu.
Moves the cursor to the right.
Resets a fault.
Starts the drive in the LOCAL mode. The Run LED
• is on, when the drive is operating the motor.
• flashes during deceleration to stop or when the frequency reference is 0.
• flashes quickly the drive is disabled by a DI, the drive was stopped
using a fast stop DI or a run command was active during power up.
Scrolls up to select parameter numbers, setting values, etc.
Stops the drive.
Selects modes, parameters and is used to store settings.
Switches drive control between the operator (LOCAL) and the control cir-
cuit terminals (REMOTE). The LED is on when the drive is in the LOCAL
mode (operation from keypad).
Flashing: The drive is in an alarm state.
On: The drive is in a fault state and the output is stopped.
On: The motor rotation direction is reverse.
Off: The motor rotation direction is forward.
On: The drive is ready to operate the motor.
Off: The drive is in the Verify, Setup, Parameter Setting or Auto tuning
mode.
On: The output frequency is displayed on the data screen.
Off: Anything else than the output frequency is displayed on the data
screen.
4 Keypad Operation
STOP
Function
15