Getting To Know Your Monitor - Angelcare AC315 Manuel De L'utilisateur

4.2 - HOW TO SET THE TIME
3
02:04 68°F
02
4
IMPORTANT
The Sensor Pad will be automatically ACTIVATED when the screen returns to video display view. If no
movement is detected on the surface of the Sensor Pad after 20 seconds, a series of loud beeps will emit
from the Parent Unit & Camera - this is the movement alarm. When activating any functions on your monitor,
to prevent this alarm either:
1) Gently tap the surface of the pad
2) De-activate the movement function, see below for information
STEP 5 - GETTING TO KNOW YOUR MONITOR
TOUCH CONTROL KEYS
Access to the different
operation settings
Navigate the different
functions
The Angelcare monitor can be used with the pre-programmed factory settings or you can also customize your
®
settings to your preference.
Movement &
Temperature Reports
General Settings
Camera Settings
Movement Sensor
Pad Settings
Temperature Settings
Pairing Units
IMPORTANT
When in menu or sub-menu modes, sound transmission between the Parent Unit and the Camera will be
temporarily deactivated. ONLY movement-detection alarm will remain active (if function is activated).
10
1) Press
1
2) Press the down arrow
3) Set the hours with the up/down arrows
04
4) Press the down arrow
2
68°F
to switch between 12 h and 24 h mode.
once and then
. Do the same for the minutes and am/pm display and confirm
with .
highlighted in blue then Press the
Exit or to go back to main menu when
in sub-menu
Confirm a selection or setting and allows
you to access to a quick menu
to set the time.
and confirm with
, the Save icon at the bottom is
button to save the settings.
68°F
Pause Sensor
Pad
Adjust LCD
Brightness
Pan & Zoom
Active Camera
Indicator