Angelcare AC315 Manuel De L'utilisateur page 8

IMPORTANT!
SECURELY PLACED UNDER THE LEG OF THE CRIB
• Ensure the Sensor Pad cable connector is locked into the Sensor Pad – check before each use.
• Ensure the Sensor Pad is in the center of the Crib – printed or Logo side up – on top of the
hardboard. Check the position is central before each use.
• Ensure there is no slack in cords and exposure of cord to child is minimised (see further
instructions within).
• When re-positioning the mattress support as your child grows, adjust the position of the
vertical cord cover (on the leg of the crib) by threading the cord through the cover and ensure
the cover is always vertically central about the leg. Remove any slack in the cord.
• BEFORE FIRST TIME USE: Test that the unit is ready for use – refer to to the Full User Manual
to check installation is correct.
STEP 3 - SETTING UP THE CAMERA UNIT
1
Note: Each time you power ON your Camera, the internal thermometer will need to calibrate to ensure accuracy.
This automatic process will take approximately 30 minutes. The colour changing temperature display, by default,
will be turned "OFF". You may turn this feature "ON" in the settings mode on your Parent Unit.
CAMERA UNIT
8
ENSURE THE CORD PROTECTIVE COVER IS
Speaker
Microphone
Camera
Room
temperature
display
Micro USB
charging port
Front Side
2
1) Connect the USB plug to the Camera.
2) Connect the USB plug with the power adapter
and then with an electrical outlet.
3) Adjust the Camera using the magnetic
mount to get the best view of baby in the
crib.
Pause Sensor Pad/
Pairing button
POWER ON/OFF
Magnet for
tabletop stand
Rear Side
and wall mount