Angelcare AC315 Manuel De L'utilisateur page 7

2
Sensor Pad
4
6
3'' (8 cm)
7
CLICK!
4
8
4
3
5
4
6
3
5
3 2
9
2
1
1) Remove the mattress from the crib.
2) Place the Sensor Pad – Angelcare
3
logo side up – on top of the
hardboard.
2
3) Run the connection pin, warning
1
label and the first 5 cord covers
down along the backside of the
crib leg, between the mattress
support and the inside edge of
the crib.
4) Bring the first 4 cord covers down
the floor, and keep the 5th cord
cover vertically, along the backside
of the crib leg, between the
mattress and the inside edge
of the crib.
5) Remove any cord slack to make
sure no parts of the cord are
loose.
6) Place the 6th cord cover
approximately 3'' (8 cm) from the
edge of the mattress support.
7) Snap together the remaining cord
covers that will run along the floor.
1
8) Remove any cord slack to make
sure no parts of the cord are
loose.
9) Peel off the double-sided tape on
the 4th cord cover and place it
securely under the crib leg.
10) Check to make sure the Sensor
Pad has not moved from position
and place the mattress back
inside the crib.
E
N
7