Angelcare AC315 Manuel De L'utilisateur page 20

FALSE ALARMS
Turn OFF the Camera.
•
• Verify the connection between the Sensor Pad and the Camera. Unplug and reconnect the cord.
• Make sure there is no bedding between the mattress and the Sensor Pad.
• If the crib has a spring or slat base, place a hardboard between the crib base and the Sensor Pad measuring at least 1/4'' (6 mm)
thick and should have minimum dimensions of 13'' x 13'' (33 x 33 cm).
• Make sure the Sensor Pad is positioned as described under the setup requirements. Sensitivity
may need to be adjusted. Refer to STEP 5.1 for more information.
ALARM WILL NOT SOUND
Avoid contact with the crib when the monitor is ON.
•
• Place crib near a solid supporting wall to avoid Sensor Pad from detecting movement from outside the crib.
You may need to decrease the sensitivity. Refer to STEP 5.1 for more information.
•
THE PARENT UNIT DOESN'T SHOW MOVEMENT AND TEMPERATURE REPORTS
Make sure the time and date is set up. Refers to STEP 4.1 & 4.2.
•
Make sure the movement and temperature function is activated. Refers to STEP 6.5.
•
20