Testing And Getting To Know Your Monitor - Angelcare AC115 Manuel Du Propriétaire

STEP 5 - TESTING AND GETTING TO KNOW YOUR MONITOR
The Angelcare monitor can be used with the pre-programmed factory settings or you can customize your
®
settings to your preference.
5.1 - MENU ACCESS AND CHANGING THE SETTINGS
The MENU settings are accessed by pressing and HOLDING the MENU button on the Parent Unit. The MENU
functions are in a loop. Each time you press the OK button briefly you
move on to the next setting. Once you have selected your preferred settings you must press EXIT MENU or your
changes will not be saved. The MENU functions are in the following order:
PRESS AND HOLD: Movement & ''TIC".......................................................................................................STEP 5.2
PRESS 1 TIME: Sound ......................................................................................................................... STEP 5.5
PRESS 2 TIMES: Sound Transmission (VOX) ......................................................................................... STEP 5.6
PRESS 4 TIMES: Temperature ................................................................................................................STEP 5.7
5.2 - ACTIVATING/DEACTIVATING THE SENSOR PAD
SET THE MOVEMENT DETECTION
Allows you to detect baby's movements.
2
All changes and adjustments
made in the main menu will
not be saved unless you
confirm them by pressing
the EXIT button.
IMPORTANT
When in MENU mode, sound transmission
between the Parent and Nursery Units will be
temporarily deactivated. The TIC indicator will
flash rapidly if no movement is detected.
1) Press and HOLD the MENU button until the
Movement monitoring
2) Use the UP and DOWN arrows to activate or
deactivate movement detection.
3) Press the OK button to go to the next setting
or press the EXIT button to confirm your
choice.
E
N
icon blinks.
11