Getting To Know Your Monitor - Angelcare AC017 Manuel De L'utilisateur

STEP 4 - GETTING TO KNOW YOUR MONITOR
4.1 TESTING THE SENSOR PAD:
1
MOVEMENT ALARM
• If NO movement is detected after 15 seconds
you will hear a single pre-alarm sound from
the Nursery Unit.
• If after a further 5 seconds there is still NO
movement detected, Nursery Unit speakers will
emit loud continuous beeps.
TO STOP THE ALARM
IMPORTANT
• Test your monitor before first use.
• Test your monitor regularly to ensure it is functioning correctly.
• Test your monitor every time you move the Sensor Pad to a different place.
4.2 PAUSING AND RESTARTING THE SENSOR PAD:
Allows you to pause the Sensor Pad if you remove baby from the crib,
e.g. for feeding or comforting.
IMPORTANT
• If you do not pause the Sensor Pad, the alarm will sound if there is no movement after
20 seconds.
• Ensure to unpause the Sensor Pad before putting baby in the crib.
6
2
Place your hand
back on the
mattress.
1) From the Nursery Unit, press the Pause button on the
1
top right of the unit.
2) The light will flash white when the Sensor Pad is
paused. The Nursery Unit will emit a single beep every
20 seconds to indicate movement function is paused.
2
3) To unpause the Sensor Pad press the Pause button
again.
1) Move your hand lightly on the mattress.
2) Remove your hand from the mattress.
After 15 seconds you will hear a pre-
alarm sound and the light will flash
red.
3
3) 5 seconds later the alarm will emit a
loud continuous beeps and the light
will flash red continuously.
IF THE ALARM DOES NOT SOUND
• Avoid contact with crib while Sensor Pad
is in operation.
• Place crib near a supporting wall.
• Adjust Sensor Pad sensitivity level.
• Turn OFF crib mobile, fans, loud music or
anything else that may cause vibration.
OR
Press Pause
on the Nursery
Unit