SilverCrest SEF3 2000 C4 Mode D'emploi page 19

Troubleshooting
PROBLEM
The appliance is not
working.
or
The Power control lamp 0
does not light up.
The Ready control lamp 9
does not light up.
If the malfunction cannot be corrected with the above suggestions, or if you have found some
other kind of malfunction, please contact our Customer Service department.
Appendix
Disposal of the appliance
Under no circumstances should you dispose of the appliance in
normal household waste.
This product is subject to the provisions of European Directive
2012/19/EU.
Dispose of the appliance via an approved waste disposal company or your
municipal waste disposal facility. Please observe applicable regulations.
Please contact your waste disposal facility if you are in any doubt.
Your local community or municipal authorities can provide information on how to
dispose of the worn-out product.
The product is recyclable, subject to extended producer responsibility and is
collected separately.
■ 16 │ GB │ IE
POSSIBLE CAUSE
The appliance is not connected
to a mains power socket.
The appliance is damaged.
The On/Off switch 8 has not
been activated.
The thermal cut-out has been
triggered.
The selected temperature for
the cooking oil/fat has not
been reached.
POSSIBLE
SOLUTIONS
Connect the appliance to
a mains power socket.
Contact the Customer
Service department.
Press the On/Off switch 8.
Switch the device off at
the On/Off switch 8 and
disconnect the mains power
plug from the mains power
socket. Wait until the appli-
ance has cooled down.
Wait a few minutes until the
required temperature has
been reached.
SEF3 2000 C4