Set Global Read-Only In Admin Mode; Enable Global Read/Write In Admin Mode - iStorage DatAshur PRO2 Manuel D'utilisation

Note: When the datAshur PRO
time the drive can accept instructions via the keypad allowing it to be configured with a host of security features. If no key event
happens within 30 seconds, the datAshur PRO
RED LED which then fades out to the Idle state (all LEDs off).
To immediately exit Admin Mode (solid
LED switches to a solid
must first be in the idle state (all LEDs off) before an Admin/User PIN can be entered.

21. Set Global Read-Only in Admin Mode

When the Administrator configures the datAshur PRO
can write to the drive and both are restricted to Read-Only access. Only the Administrator is able to change the setting back to Read/Write
as described in section 22.
To set the datAshur PRO and restrict Global access to Read-Only, first enter the "Admin Mode" as described in section 5. Once the
2
drive is in Admin Mode (solid
1. In Admin mode, press and hold down both "5 + 6"
buttons.
2. Press KEY ( ) button
Note: When the datAshur PRO
time the drive can accept instructions via the keypad allowing it to be configured with a host of security features. If no key event
happens within 30 seconds, the datAshur PRO
RED LED which then fades out to the Idle state (all LEDs off).
To immediately exit Admin Mode (solid
LED switches to a solid
must first be in the idle state (all LEDs off) before an Admin/User PIN can be entered.

22. Enable Global Read/Write in Admin Mode

To set the datAshur PRO back to Read/Write from the Global Read-Only setting, first enter the "Admin Mode" as described in section
2
5. Once the drive is in Admin Mode (solid
1. In Admin mode, press and hold down both "5 + 9"
buttons.
2. Press KEY ( ) button
#20
is in Admin Mode, the
2
will exit Admin mode automatically - the solid
2
BLUE LED), press and hold down the SHIFT (
RED LED which then fades out to the Idle state. To access the drive contents (data), the datAshur PRO
and restricts it to Global Read-Only, then neither the Administrator nor the User
2
BLUE LED) proceed with the following steps.
is in Admin Mode, the
2
will exit Admin mode automatically - the solid
2
BLUE LED), press and hold down the SHIFT (
RED LED which then fades out to the Idle state. To access the drive contents (data), the datAshur PRO
BLUE LED) proceed with the following steps.
BLUE LED will remain on and solid for 30 seconds only, during which
Solid
BLUE
GREEN
GREEN
indicating the drive has been configured and
restricts Global access to Read-Only
BLUE LED will remain on and solid for 30 seconds only, during which
Solid
BLUE
GREEN
LED then to a solid
indicating the drive is configured as Read/Write
www.istorage-uk.com
BLUE LED switches to a solid
) button for a second - the solid
BLUE LED will change to blinking
LEDs
and BLUE LEDs will change to a solid
LED and then to a solid BLUE
BLUE LED switches to a solid
) button for a second - the solid
BLUE LED will change to blinking
LEDs
and BLUE LEDs change to a solid
BLUE LED
BLUE
2
GREEN and
LED
BLUE
2
GREEN and
GREEN