Note: When datAshur PRO
within 30 seconds, the device will enter Idle State automatically. The LED turns to solid
out to the idle state.
When datAshur PRO
When connected to a powered USB port, a locked datAshur PRO
indicated by the
BLUE
Power-on States
After the device wakes from Idle State, it will enter one of the following states shown in the table below.
Power-on State
LED indication
Standby
RED
RED
Reset
RED
Low Battery Level
Times
RED
Initial Shipment State
Solid
3. First Time Use
datAshur PRO
is supplied in the 'Initial Shipment State' with no pre-set Admin PIN. A 7-15 digit Admin PIN must be config-
2
ured before the drive can be used. Once an Admin PIN has been successfully configured, it is then not possible to switch the drive back
to the 'Initial Shipment State'.
PIN Requirements:
•
Must be between 7-15 digits in length
•
Must not contain only repetitive numbers, e.g. (3-3-3-3-3-3-3)
•
Must not contain only consecutive numbers, e.g. (1-2-3-4-5-6-7), (7-8-9-0-1-2-3-4), (7-6-5-4-3-2-1)
Password
Tip: You can configure a memorable word, name, phrase or any other Alphanumerical PIN combination
by simply pressing the button with the corresponding letters on it.
Examples of these types of Alphanumerical PINs are:
• For "Password" press the following buttons:
7 (pqrs) 2 (abc) 7 (pqrs) 7 (pqrs) 9 (wxyz) 6 (mno) 7 (pqrs) 3 (def)
• For "iStorage" press the following buttons:
4 (ghi) 7 (pqrs) 8 (tuv) 6 (mno) 7 (pqrs) 2 (abc) 4 (ghi) 3 (def)
Using this method, long and easy to remember PINs can be configured.
is unlocked and not connected to a USB port and no operations are performed
2
is connected to a USB port, the SHIFT (
2
LED blinking every 5 seconds.
Encryption
Key
Solid
Solid
Blinks 3
and
GREEN
) button does not function.
will start charging after 30 seconds,
2
Admin
Description
PIN
Waiting for Admin or User PIN entry
Waiting for configuration of an Admin PIN
Charge on a powered USB port for 15-30 minutes
Waiting for configuration of an Admin PIN
www.istorage-uk.com
RED
and then fades
#7