Turn Off The Unattended Auto-Lock Clock - iStorage DatAshur PRO2 Manuel D'utilisation

To set the Unattended Auto Lock time-out, first enter the "Admin Mode" as described in section 5. Once the drive is in Admin Mode
(solid BLUE LED) proceed with the following steps.
1. In Admin mode, press and hold down both
KEY ( ) + 5 buttons
2. Enter the amount of time that you would like to set the Auto-Lock time-out feature for, the minimum time that can
be set is 5 minutes and the maximum being 99 minutes (5-99 minutes). For example enter:
05 for 5 minutes (press '0' followed by a '5')
20 for 20 minutes (press '2' followed by a '0')
99 for 99 minutes (press '9' followed by another '9')
3. Press the SHIFT ( ) button
Note: When the datAshur PRO
time the drive can accept instructions via the keypad allowing it to be configured with a host of security features. If no key event
happens within 30 seconds, the datAshur PRO
RED LED which then fades out to the Idle state (all LEDs off).
To immediately exit Admin Mode (solid
LED switches to a solid
must first be in the idle state (all LEDs off) before an Admin/User PIN can be entered.

28. Turn off the Unattended Auto-Lock Clock

To turn off the Unattended Auto Lock, first enter the "Admin Mode" as described in section 5. Once the drive is in Admin Mode (solid
BLUE LED) proceed with the following steps.
1. In Admin mode, press and hold down both
KEY ( ) + 5 buttons
2. Enter 00 and press the SHIFT (
Note: When the datAshur PRO
time the drive can accept instructions via the keypad allowing it to be configured with a host of security features. If no key event
happens within 30 seconds, the datAshur PRO
RED LED which then fades out to the Idle state (all LEDs off).
To immediately exit Admin Mode (solid
LED switches to a solid
must first be in the idle state (all LEDs off) before an Admin/User PIN can be entered.
#24
is in Admin Mode, the
2
will exit Admin mode automatically - the solid
2
BLUE LED), press and hold down the SHIFT (
RED LED which then fades out to the Idle state. To access the drive contents (data), the datAshur PRO
) button
is in Admin Mode, the
2
will exit Admin mode automatically - the solid
2
BLUE LED), press and hold down the SHIFT (
RED LED which then fades out to the Idle state. To access the drive contents (data), the datAshur PRO
Solid
and BLUE
Blinking
solid
BLUE
successfully configured
BLUE LED will remain on and solid for 30 seconds only, during which
Solid
and BLUE
Blinking
solid
BLUE
been successfully disabled
BLUE LED will remain on and solid for 30 seconds only, during which
www.istorage-uk.com
BLUE LED will change to blinking
LEDs
GREEN and BLUE LEDs will change to a
GREEN for a second and then finally to a solid
LED indicating the Auto-Lock time out is
BLUE LED switches to a solid
) button for a second - the solid
BLUE LED will change to blinking
LEDs
GREEN and BLUE LEDs will change to a
GREEN for a second and then finally to a solid
LED indicating the Auto-Lock time out has
BLUE LED switches to a solid
) button for a second - the solid
GREEN
BLUE
2
GREEN
BLUE
2