Led Indicators And Their Actions; Battery And Led States - iStorage DatAshur PRO2 Manuel D'utilisation

1. LED indicators and their actions

LED LED State
RED Solid
RED - Fade Out
GREEN Blinking
GREEN Solid
BLUE Solid

2. Battery and LED States

Note: The normal function of the datAshur PRO
ply power cycle the product (power off then power on) to resume normal operation. If normal operation does not resume,
please use the product in a different location.
Low Battery Sensor
The datAshur PRO incorporates voltage detection circuitry that monitors the battery output when the device is powered on. When battery
2
output drops to 3.3V or below, the
to a powered USB port and charge for 15-30minutes. Once recharged, the datAshur PRO
To wake from Idle State
Idle state is defined as when datAshur PRO
To wake datAshur PRO from the idle state do the following.
2
Press and hold down the SHIFT (
one second or connect the device to a powered
USB port
To enter Idle State
To force datAshur PRO to enter Idle State, execute either of the following operations:
2
• If the device is connected to a USB port, disconnect it.
• If the device is not connected to a USB port, press and hold down the SHIFT (
turns solid RED and fades out to the Idle State (off).
#6
Description
Locked device (in either
Standby or Reset states)
Device Turning off to the
Idle State
Unlocked device as Admin
(not connected to USB port)
Unlocked device as User
(not connected to USB port) or
device in User mode
Device in Admin mode
2
RED LED flashes three times and fades out. At this point, the User should connect the datAshur PRO
is not being used and all LEDs are off.
2
) button for
www.istorage-uk.com
LED LED State
RED, GREEN
BLUE Blinking
GREEN and
Blinking together
GREEN and
Blinking alternately
BLUE blinking every
5 seconds
may be disturbed by strong Electro-Magnetic Interference. If so, sim-
will resume normal function.
2
RED, GREEN and BLUE LEDs blink once in sequence then the
LED blinks twice and finally switches to a solid
the device is in Standby State
Description
and
Waiting for User PIN entry
BLUE
Waiting for Admin PIN entry
BLUE
Authentication in progress
Battery starts charging after 30
seconds when device is locked
and connected to a USB port
RED LED indicating
) button for a second until the LED
2
GREEN