Changing The User Pin In Admin Mode; Deleting The User Pin In Admin Mode - iStorage DatAshur PRO2 Manuel D'utilisation

12. Changing the User PIN in Admin Mode

Important: Changing the User PIN must comply with the 'User PIN Policy' if one has been configured as described in
section 8, which imposes a minimum PIN length and whether a 'Special Character' has been
used. Refer to section 10 to check the user PIN restrictions.
To change an existing User PIN, first enter the "Admin Mode" as described in section 5. Once the drive is in Admin Mode (solid
BLUE LED) proceed with the following steps.
1. In Admin mode press and hold down both
KEY ( ) + 3 buttons
2. Enter New User PIN and press KEY ( ) button
3. Re-enter the New User PIN and press KEY ( )
button again
Note: When the datAshur PRO
time the drive can accept instructions via the keypad allowing it to be configured with a host of security features. If no key event
happens within 30 seconds, the datAshur PRO
RED LED which then fades out to the Idle state (all LEDs off).
To immediately exit Admin Mode (solid
LED switches to a solid RED
must first be in the idle state (all LEDs off) before an Admin/User PIN can be entered.

13. Deleting the User PIN in Admin Mode

To delete an existing User PIN, first enter the "Admin Mode" as described in section 5. Once the drive is in Admin Mode (solid
BLUE LED) proceed with the following steps.
1. In Admin mode press and hold down both
SHIFT ( ) + 3 buttons
2. Press and hold down both
SHIFT ( ) + 3 buttons again
is in Admin Mode, the BLUE
2
will exit Admin mode automatically - the solid
2
BLUE LED), press and hold down the SHIFT (
LED which then fades out to the Idle state. To access the drive contents (data), the datAshur PRO
www.istorage-uk.com
Solid BLUE LED will change to blinking
solid BLUE LEDs
Blinking GREEN
a single GREEN
GREEN and solid
Blinking GREEN
rapidly blinking
BLUE LED indicating the User PIN has been suc-
cessfully changed
LED will remain on and solid for 30 seconds only, during which
) button for a second - the solid
Solid BLUE LED will change to a blinking
Blinking RED
and then to a solid
PIN has been successfully deleted
GREEN
and solid BLUE LEDs will switch to
LED blink and then back to blinking
BLUE LEDs
and solid BLUE LEDs change to a
GREEN LED and finally to a solid
BLUE LED switches to a solid
RED
LED will change to a solid RED
BLUE LED indicating the User
and
BLUE
2
LED
LED
#15