Set User Read-Only In Admin Mode; Enable User Read/Write In Admin Mode - iStorage DatAshur PRO2 Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

19. Set User Read-Only in Admin Mode

With so many viruses and Trojans infecting USB drives, the Read-Only feature is especially useful if you need to access data on the USB
drive when used in a public setting. This is also an essential feature for forensic purposes, where data must be preserved in its original
and unaltered state that cannot be modified or overwritten.
When the Administrator configures the datAshur PRO
the drive or change the setting back to Read/Write as described in section 20. The User is restricted to Read-Only access and cannot
write to the drive or change this setting in user mode.
To set the datAshur PRO
and restrict User access to Read-Only, first enter the "Admin Mode" as described in section 5. Once the drive
2
is in Admin Mode (solid
BLUE
1. In Admin mode, press and hold down both "7 + 6"
buttons.
2. Press KEY ( ) button
Note:
When the datAshur PRO
time the drive can accept instructions via the keypad allowing it to be configured with a host of security features. If no key event
happens within 30 seconds, the datAshur PRO
RED
LED which then fades out to the Idle state (all LEDs off).
To immediately exit Admin Mode (solid
LED switches to a solid
RED
must first be in the idle state (all LEDs off) before an Admin/User PIN can be entered.

20. Enable User Read/Write in Admin Mode

To set the datAshur PRO
back to Read/Write, first enter the "Admin Mode" as described in section 5. Once the drive is in
2
Admin Mode (solid
BLUE
LED) proceed with the following steps.
1. In Admin mode, press and hold down both "7 + 9"
buttons.
2. Press KEY ( ) button
and restricts User access to Read-Only, then only the Administrator can write to
2
LED) proceed with the following steps.
is in Admin Mode, the
BLUE
2
will exit Admin mode automatically - the solid
2
BLUE
LED), press and hold down the SHIFT (
LED which then fades out to the Idle state. To access the drive contents (data), the datAshur PRO
www.istorage-uk.com
Solid
BLUE
LED will change to blinking
BLUE
LEDs
GREEN
and
BLUE
GREEN
LED and then to a solid
indicating the drive has been configured and
restricts User access to Read-Only
LED will remain on and solid for 30 seconds only, during which
) button for a second - the solid
Solid
BLUE
LED will change to blinking
BLUE
LEDs
GREEN
and
BLUE
LED then to a solid
indicating the drive is configured as Read/Write
GREEN
LEDs will change to a solid
BLUE
LED
BLUE
LED switches to a solid
BLUE
GREEN
LEDs change to a solid
GREEN
BLUE
LED
and
2
and
#19

Publicité

Table des Matières
loading

Table des Matières