How To Check Firmware In User Mode - iStorage DatAshur PRO2 Manuel D'utilisation

44. How to check Firmware in User Mode

To check the firmware revision number, first enter the "User Mode" as described in section 14. Once the drive is in User Mode (solid
GREEN LED) proceed with the following steps.
1. In User mode press and hold down both "3 + 8"
buttons until GREEN and BLUE
2. Press the KEY ( ) button and the following happens;
a. All LED's (RED, GREEN & BLUE) become solid for 1 second.
b. RED LED blinks indicating the integral part of the firmware revision number.
c. GREEN LED blinks indicating the fractional part.
d BLUE LED blinks indicating the last digit of the firmware revision number
e. All LED's (RED, GREEN & BLUE) become solid for 1 second.
f. RED, GREEN & BLUE LEDs switch to a solid
For example, if the firmware revision number is '2.3', the
Once the sequence has ended the RED,
LED.
LEDs blink together
BLUE LED
RED LED will blink twice (2) and the
GREEN & BLUE LED's will blink together once and then return to the User mode, a solid
www.istorage-uk.com
Solid GREEN LED will change to blinking
and BLUE LEDs
GREEN LED will blink three (3) times.
GREEN
GREEN
#39