How To Verify Whether An Admin/User Pin Has Been Set Up; How To Enable Read-Only In Admin Mode; How To Enable Read/Write In Admin Mode - iStorage datashur PRO Manuel D'utilisation

15. How to verify whether an Admin/User PIN has been set up

The following table illustrates how to determine which PINs, User and/or Admin, have been set up.
With the datAshur PRO in a locked state (all LEDs off), press the KEY button once.
1. Press KEY button once
Only User/default PIN exists
Only Admin PIN exists
Both User and Admin PIN's exist

16. How to enable Read-Only in Admin mode

When Admin writes content to the datAshur PRO and restricts access to read-only, the User cannot change this setting in
User mode. To set the datAshur PRO to Read-Only, please follow the steps below.
Caution:
Entering the Admin PIN to access a locked drive will clear the User PIN. For security reasons, we
highly recommend that a new User PIN be created immediately once the drive has been unlocked
using the Admin PIN. Refer to section 13 on page 12.
Instructions
1. Unlock the datAshur PRO with Admin PIN
2. Press the KEY button three times
(treble-click)
3. Within 10 seconds begin to press the number 7 (pqRs)
button followed by the number 6 (mnO) button (76)
4. Press KEY button once

17. How to enable Read/Write in Admin mode

Admin can override User set Read-Only by enabling Read/Write on the datAshur PRO using the Admin PIN. To set the
datAshur PRO to Read/Write, please follow the steps below.
Caution: Entering the Admin PIN to access a locked drive will clear the User PIN. For security reasons, we
highly recommend that a new User PIN be created immediately once the drive has been unlocked
using the Admin PIN. Refer to section 13 on page 12.
#14
Red, Green & Blue LED's will flash together once, then one of the following states occurs.
www.istorage-uk.com www.istorage-uk.com
Red LED blinks
Blue LED blinks
&
Red and Blue LED's blink together
LED LED State
Red solid LED followed by a flickering
LED indicating successful Admin PIN entry
Green and Blue
&
Green and Blue
&
together
Red solid LED changing to flickering
LED. when the datAshur PRO is inserted into
a USB port the
seconds indicating the datAshur PRO is in
Read-Only mode
Green
LED's flicker together
LED's continue to flicker
Green
Green LED blinks every two
#14