How To Check The Unattended Auto-Lock Clock; Set Read-Only In User Mode - iStorage DatAshur PRO2 Manuel D'utilisation

29. How to check the Unattended Auto-Lock Clock

The Administrator is able to check and determine the length of time set for the unattended auto-lock clock by simply noting the LED
sequence as described on the table at the bottom of this page.
To check the unattended auto-lock, first enter the "Admin Mode" as described in section 5. Once the drive is in Admin Mode (solid
BLUE LED) proceed with the following steps.
1. In Admin mode press and hold down
SHIFT ( ) + 5
2. Press the KEY ( ) button and the following happens;
a. All LED's (RED, GREEN & BLUE) become solid for 1 second.
b. Each RED LED blink equates to ten (10) minutes.
c. Every GREEN LED blink equates to one (1) minute.
d. All LED's (RED, GREEN & BLUE) become solid for 1 second.
e. LEDs return to solid BLUE
The table below describes the LED behaviour whilst checking the unattended auto-lock, for instance if you have set the drive to automati-
cally lock after 25 minutes, the
Auto-Lock in minutes
5 minutes
15 minutes
25 minutes
40 minutes
Note:
When the datAshur PRO
time the drive can accept instructions via the keypad allowing it to be configured with a host of security features. If no key event
happens within 30 seconds, the datAshur PRO
RED LED which then fades out to the Idle state (all LEDs off).
To immediately exit Admin Mode (solid
LED switches to a solid RED
must first be in the idle state (all LEDs off) before an Admin/User PIN can be entered.

30. Set Read-Only in User Mode

To set the datAshur PRO to Read-Only, first enter the "User Mode" as described in section 14. Once the drive is in User Mode (solid
2
GREEN LED) proceed with the following steps.
1. In User mode, press and hold down both "7 + 6"
buttons. (7=Read + 6=Only)
2. Press KEY ( ) button
RED LED will blink twice (2) and the
is in Admin Mode, the BLUE
2
will exit Admin mode automatically - the solid
2
BLUE LED), press and hold down the SHIFT (
LED which then fades out to the Idle state. To access the drive contents (data), the datAshur PRO
www.istorage-uk.com
Solid BLUE
BLUE LEDs
GREEN LED will blink five (5) times.
RED GREEN
0 5 Blinks
1 Blink 5 Blinks
2 Blinks 5 Blinks
4 Blinks 0
LED will remain on and solid for 30 seconds only, during which
) button for a second - the solid
Solid GREEN
and BLUE LEDs
GREEN and
GREEN LED indicating the drive is configured as
Read-Only
LED will change to blinking GREEN
BLUE LED switches to a solid
LED will change to blinking
BLUE LEDs will change to a solid
and
BLUE
2
GREEN
#25