How To Unlock Datashur Pro; With User Pin; Changing The User Pin In User Mode - iStorage DatAshur PRO2 Manuel D'utilisation

Note: When the datAshur PRO
time the drive can accept instructions via the keypad allowing it to be configured with a host of security features. If no key event
happens within 30 seconds, the datAshur PRO
RED LED which then fades out to the Idle state (all LEDs off).
To immediately exit Admin Mode (solid
LED switches to a solid
must first be in the idle state (all LEDs off) before an Admin/User PIN can be entered.
14.

How to Unlock datAshur PRO

To unlock with the User PIN, the datAshur PRO
SHIFT ( ) button for one second.
1. In a standby state (solid
down both the SHIFT (
2. Enter User PIN and press the KEY ( ) button
15.

Changing the User PIN in User Mode

To change the User PIN, first unlock the datAshur PRO
Mode (solid GREEN LED) proceed with the following steps.
1. In User mode press and hold down
both KEY ( ) + 4
2. Enter New User PIN and press the KEY ( )
button
3. Re-enter New User PIN and press the KEY ( )
button
Important: Changing the User PIN must comply with the 'User PIN Policy' if one has been configured as described in
section 8, which imposes a minimum PIN length and whether a 'Special Character' has been
used. The administrator can refer to section 10 to check the user PIN restrictions.
#16
is in Admin Mode, the
2
will exit Admin mode automatically - the solid
2
BLUE LED), press and hold down the SHIFT (
RED LED which then fades out to the Idle state. To access the drive contents (data), the datAshur PRO
must first be in Standby State (solid
2
RED LED) Press and hold
) + KEY ( ) buttons
with a User PIN as described above in section 14. Once the drive is in User
2
BLUE LED will remain on and solid for 30 seconds only, during which

with User PIN

2
RED
RED LED switches to all LEDs, RED,
BLUE
RED, GREEN
to alternating
solid GREEN
unlocked in User Mode
Solid GREEN
LED and a solid
Blinking
a single
GREEN
Blinking
to a rapidly blinking
GREEN
successful User PIN change
www.istorage-uk.com
BLUE LED switches to a solid
) button for a second - the solid
LED) by pressing and holding down the
blinking on and off
and BLUE blinking LEDs will change
GREEN and BLUE LEDs then to a
LED indicating drive successfully
LED will change to a blinking
BLUE LED
GREEN and solid BLUE LEDs will switch to
GREEN LED blink and then back to blinking
and solid BLUE LEDs
GREEN and solid BLUE LEDs will switch
GREEN LED and then to a solid
LED indicating a
BLUE
2
GREEN &
GREEN