How To Verify Whether An Admin/User Pin Has Been Set Up; How To Enable Read-Only In Admin Mode; How To Enable Read/Write In Admin Mode - iStorage DATAshur 2 personal Manuel D'utilisation

15. How to verify whether an Admin/User PIN has been set up

The following table illustrates how to determine which PINs, User and/or Admin, have been set up.
With the datAshur Personal
1. Press KEY button once
Only User/default PIN exists
Only Admin PIN exists
Both User and Admin PIN's exist

16. How to enable Read-Only in Admin mode

When Admin writes content to the datAshur Personal
User mode. To set the datAshur Personal
Caution:
Entering the Admin PIN to access a locked drive will clear the User PIN. For security reasons, we
highly recommend that a new User PIN be created immediately once the drive has been unlocked
using the Admin PIN. Refer to section 13 on page 12.
Instructions
1. Unlock the datAshur Personal
2. Press the KEY button three times
(treble-click)
3. Within 10 seconds begin to press the number 7 (pqRs)
button followed by the number 6 (mnO) button (76)
4. Press KEY button once

17. How to enable Read/Write in Admin mode

Admin can override User set Read-Only by enabling Read/Write on the datAshur Personal
datAshur Personal to Read/Write, please follow the steps below.
2
Caution: Entering the Admin PIN to access a locked drive will clear the User PIN. For security reasons, we
highly recommend that a new User PIN be created immediately once the drive has been unlocked
using the Admin PIN. Refer to section 13 on page 12.
#14
in a locked state (all LEDs off), press the KEY button once.
2
Red, Green & Blue LED's will flash together once, then one of the following states occurs.
and restricts access to read-only, the User cannot change this setting in
2
to Read-Only, please follow the steps below.
2
with Admin PIN
2
Red LED blinks
Blue LED blinks
&
Red and
LED LED State
Red solid LED followed by a flickering
LED indicating successful Admin PIN entry
Green
&
Green
&
together
Red solid LED changing to flickering
LED. when the datAshur Personal
into a USB port the
seconds indicating the datAshur Personal
Read-Only mode
www.istorage-uk.com www.istorage-uk.com
Blue LED's blink together
and Blue LED's flicker together
and Blue LED's continue to flicker
2
Green LED blinks every two
using the Admin PIN. To set the
2
Green
Green
is inserted
is in
2
#14