Setting The Contact Pressure En; Feeding In The Wire En - Abicor Binzel MF1 Mode D'emploi

6 Commissioning
6.1.4 Setting the contact pressure
The contact pressure has a defined start and end point.
1 Rocker arm
2 Sleeve
Fig. 5 Setting the contact pressure
NOTICE
• One rotation of the screw (4) corresponds to 80 N.
If the screw (4) is fully tightened, this corresponds to a force of 200 N. The mark (3) on the screw (4) points upwards and
coincides with the mark on the sleeve (2).
The screw can be turned a maximum of 2.5 rotations.
6.2 Feeding in the wire
1
1 Pressure lever
2 Wire guide speed sensor
3 Eccentric bolt
Fig. 6 Feeding in the wire
EN - 12
1 2
2 3
9
4 Wire guide
5 Wire
6 Cable assembly interface
3
3 Mark
4 Screw
4 5
8
7 Inching trigger (green)
8 Rocker arm
9 Wire actual value encoder (AVT)
MF1
4
6
7
BAL.0183.0 • 2018-08-08