Troubleshooting - Abicor Binzel MF1 Mode D'emploi

MF1

10 Troubleshooting

DANGER
Risk of injury and machine damage when handled by unauthorized persons
Incorrect repair work and changes of the product may lead to significant injuries and damage to the device. The product
warranty will be rendered invalid if work is carried out on the product by unauthorized persons.
• Operating, maintenance, cleaning and repair work may be carried out only by qualified personnel
(in Germany see TRBS 1203).
Please observe the attached document 'Warranty'. Please consult your retailer or the manufacturer in case of any doubts
and/or problems.
NOTICE
• Please also consult the operating instructions for the welding components, such as the power source, welding torch
system, re-circulating cooling unit etc.
Fault Cause
Unit is not ready for • Control system or component defective
operation
• Motor defective (master or slave)
Wire is not fed
• Motor control card fault. Fault cannot be eliminated
by pressing the RESET trigger
• When the wire feed trigger is pressed again, the
motor control card shows again a fault
Tab. 15 Troubleshooting
BAL.0183.0 • 2018-08-08
10 Troubleshooting
Solution
• Check by specialized personnel
• Switch unit to currentless state!
• Replace motor, press RESET trigger
• Replace motor control card
• Replace the feed motor or motor control card
• Wire fault in cable assembly or master drive
Eliminate fault
EN - 17