Functional Description; Commissioning - Abicor Binzel MF1 Mode D'emploi

Entrainement maitre avec transmetteur de valeur reelle
Masquer les pouces Voir aussi pour MF1:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

MF1

5 Functional description

The media required for the welding process (welding current, shielding gas, coolant and blast air) are passed through the
MF1 master feeder and fed to the torch. The interfaces with the torch and the cable assembly are adapted to the application-
specific requirements. The MF1 master feeder is fastened to the robot or the safety cut-out by means of a robot mount. The
four-roll drive feeds the wire at a constant wire feed. The master feeder takes over the "Push" function here. The wire can be
fed directly by means of a MasterLiner or by means of a second slave drive that is tuned exactly to the master feeder. This
slave drive is integrated, for example, into the M-Drive, MF1-Rear or a power source.
1
8
7
1
Quick coupling interface
2
MF1 master feeder with wire actual
value encoder
3
Cable assembly clutch
Fig. 2
Functional description

6 Commissioning

DANGER
Risk of injury due to unexpected start-up
The following instructions must be followed during all maintenance, servicing, assembly, disassembly, and repair work:
• Switch off the power source.
• Close off the gas and coolant supply.
• Close off the compressed air supply.
• Switch off the entire welding system.
• Disconnect all electrical connections.
WARNING
Risk of crushing
Hands can be pulled in and crushed by moving wheels.
• Do not reach into moving wheels.
BAL.0183.0 • 2018-08-08
2
6
4
Quick coupling
5
16-pin motor control lead port
6
4-pin wire actual value encoder control lead
port
5 Functional description
3
4
5
7
Interface WH
®
8
Interface ABIROB
W
EN - 9

Publicité

Table des Matières
loading

Table des Matières