Operation; Control Elements En; Decommissioning - Abicor Binzel MF1 Mode D'emploi

7 Operation

7 Operation
NOTICE
• The system may only be operated by qualified personnel (in Germany see TRBS 1203).
• Before connecting the cable assembly to the wire feeder, check whether the proper wire guide (liner or PA liner) in
accordance with the wire diameter and wire type has been inserted.
7.1 Control elements
1 4-pin wire actual value encoder control
lead port
Fig. 8 Control elements
Symbol Name
Inching trigger (green) (5). Press trigger once, wire is fed.
Gas test trigger (black) (4). Press trigger for gas flow.
Connect the CAT socket (2), to the helix cable of the CAT emergency stop safety cut-out. The integrated
control lead will transmit the signal to peripheral devices.
Motor control lead port (3). Connect the cable assembly connection plug to the motor control lead
port (3) to establish signal transmission for the motor, incl. gas and CAT signal.
4-pin wire actual value encoder control lead port (1). Connect the cable assembly connection plug to
the motor control lead port (3) to establish signal transmission.

8 Decommissioning

NOTICE
• As the MF1 master feeder is integrated into a welding system, the process for putting it out of operation depends on
the robot control system. Please make sure that the shutdown procedures for all components integrated in the welding
system are strictly observed.
1 Switch off the robot control.
EN - 14
1
5
2 CAT socket
3 16-pin motor control lead port
2
4
4 Gas test trigger (black)
5 Inching trigger (green)
MF1
3
BAL.0183.0 • 2018-08-08