Inspecting The Wire Guide Nipple En; Maintenance Intervals En - Abicor Binzel MF1 Mode D'emploi

9 Maintenance and cleaning
9.2 Inspecting the wire guide nipple
1 Wire guide at the
MasterLiner wire inlet
Fig. 10 Wire guide nipple MF1
1 Wire guide nipple okay
Fig. 11 Wear to the wire guide nipple
9.3 Maintenance intervals
NOTICE
• The specified maintenance intervals are standard values and refer to single-shift operation.
• Visually inspect the toothed wheels once a week.
• The higher the rocker arm force, the greater the wear to the toothed wheels.
When using arc welding equipment, always observe the provisions of EN 60974-4 Inspection and testing, as well as any
national laws and regulations.
Check the following:
Weekly
• The basic cleaning is recommended, and necessary in
case of extreme working conditions.
• Blow compressed air through the wire conduit and check
for wear.
• Visual inspection for abrasion or damage to the gears.
 9.1 Wear to the toothed wheels on page EN-15
• Visual inspection of the wire guide nipple.
 9.2 Inspecting the wire guide nipple on page EN-16
Tab. 14 Maintenance intervals
EN - 16
1
2 Wire guide nipple between the
drive wheels
2 3
3 Wire guide
speed sensor
2 Wire guide nipple not okay – replace
Monthly
• Oil all moving parts and roll bearings with suitable
lubricating oil.
MF1
4
4 Wire guide at wire outlet
(e.g. for flex supply)
BAL.0183.0 • 2018-08-08