Disassembly - Abicor Binzel MF1 Mode D'emploi

11 Disassembly

11 Disassembly
DANGER
Risk of injury due to unexpected start-up
The following instructions must be followed during all maintenance, servicing, assembly, disassembly, and repair work:
• Switch off the power source.
• Close off the gas and coolant supply.
• Close the compressed air supply.
• Switch off the entire welding system.
• Disconnect all electrical connections
NOTICE
• Disassembly may be carried out only by qualified personnel (in Germany see TRBS 1203).
• Observe the information provided in the following section:
 8 Decommissioning on page EN-14
1 Disconnect the cable assembly from the wire feeder.
2 Remove the parts to be disconnected.
3 Dismounting the master feeder MF1 from the torch side fastener.
EN - 18
MF1
BAL.0183.0 • 2018-08-08