Disposal - Abicor Binzel MF1 Mode D'emploi

MF1

12 Disposal

When disposing of the system, local regulations, laws, provisions, standards and guidelines must be observed. Observe the
regulations on the disposal of electronic scrap and dispose of it at your local waste disposal site (e. g. recycling centre).
To correctly dispose of the product, it must first be disassembled. Please note the following information:
 11 Disassembly on page EN-18
12.1 Materials
This product is mainly made of metallic materials, which can be melted in steel and iron works and are, thus, almost infinitely
recyclable. The plastic materials used are labeled in preparation for their sorting and separation for later recycling.
12.2 Consumables
Oil, greases and cleaning agents may not contaminate the ground or enter the sewage system. These materials must be
stored, transported and disposed of in suitable containers. Observe the relevant local regulations and disposal instructions
of the safety data sheets specified by the manufacturer of the consumables. Contaminated cleaning tools (brushes, rags, etc.)
must also be disposed of in accordance with the information provided by the consumables' manufacturer.
12.3 Packaging
ABICOR BINZEL has reduced the transport packaging to the necessary minimum. The ability to recycle packaging
materials is always considered during their selection.
BAL.0183.0 • 2018-08-08
12 Disposal
EN - 19