Setting The Contact Pressure En; Feed In Wire En - Abicor Binzel MF1 Mode D'emploi

6 Putting into operation
6.1.4 Setting the contact pressure
The contact pressure has a defined start and end point.
1
2
Fig. 5
NOTICE
• One rotation of the screw (3) corresponds to 80 N.
If the screw (3) is fully tightened, this corresponds to a force of 200 N. The mark (4) on the screw (3) points
upwards and coincides with the mark on the sleeve (2).
The screw can be turned a maximum of 2.5 rotations.
6.2 Feed in wire
1 2
1 Pressure lever
2 Wire guide speed sensor
3 Eccentric bolt
Fig. 6 Feed in wire
EN - 12
1
Pressure rocker
Sleeve
Setting the contact pressure
3
9
4 Wire guide
5 Wire
6 Interface
2 3
3 Screw
4 Mark
4 5
8
7 Inching trigger (green)
8 Pressure rocker
9 Wire actual value encoder (ATV)
MF1
4
6
7