Mounting The Feed Rollers En - Abicor Binzel MF1 Mode D'emploi

6 Commissioning
NOTICE
• Please take note of the following instructions:
 3 Product description on page EN-5
• The system may be installed and commissioned only by qualified personnel (in Germany, see TRBS 1203).
• When supplied with a CAT robot mount, isolation is required. If an alternative mounting device is used, the housing
must be attached to this in an isolated manner.
1
9
1 Protection cap
2 Drive gears (2 pcs.)
3 Knurled screws for drive rollers
Fig. 3 Putting into operation
X : View
6.1 Mounting the feed rollers
NOTICE
• Ensure that the knurled screws are correctly installed. Use these for drive rollers and pressure rollers. Ensure that the
feed rollers are correctly installed; use them for drive rollers and pressure rollers.
• The feed rollers come with anti-corrosion protection. Prior to mounting, lubricate the feed rollers and always replace or
reverse them in pairs.
• Observe the groove geometry and the wire diameter.
• Only use smooth feed rollers (e.g. for feeding CuSi, steel or stainless steel) as pressure rollers.
All grooved feed rollers have two guide grooves. Should a guide groove be worn out, then the feed roller can be reversed
once and used again.
EN - 10
2
X
8
4 Drive gear with groove
5 Toothed wheel axles (2 pcs.)
6 Rocker arm
X
7
7 Drive gears (2 pcs.)
8 Knurled screw
9 Eccentric bolt
BAL.0183.0 • 2018-08-08
MF1
3
4
5
6