Pressure Rollers En; Drive Rollers; Replacing The Rocker Arm En - Abicor Binzel MF1 Mode D'emploi

MF1
6.1.1 Pressure rollers
 Fig. 3 Putting into operation on page EN-10
1 Lift off the protection cap (1).
2 Rotate the eccentric bolt (9) and remove it upwards.
3 Open the rocker arm (6).
4 Unscrew the toothed wheel axles (5) and remove them upwards.
5 Remove the drive gears (7).
6 Remount all components in the reverse order.

6.1.2 Drive rollers

 Fig. 3 Putting into operation on page EN-10
NOTICE
• Red drive rollers = V-groove / blue drive rollers = U-groove / green drive rollers = knurled V-groove.
• An engraved number indicates the wire diameter to be used.
 Fig. 6 Feeding in the wire on page EN-12
1 Wire feed roll
Fig. 4 Wire feed roll knurled V-groove
 Fig. 3 Putting into operation on page EN-10
1 Unscrew the drive roller knurled screws (3).
2 Place the feed drive rollers on drive gears (2).
3 Remount the drive roller knurled screws (3).
6.1.3 Replacing the rocker arm
 Fig. 3 Putting into operation on page EN-10
1 Lift off the protection cap (1).
2 Rotate the eccentric bolt (9) and remove it upwards.
3 Open the rocker arm (6).
4 Unscrew the knurled screw (8).
5 Remove the rocker arm (6) upwards.
6 Place the new rocker arm (6) on the rotation axis and secure it with the knurled screw (8).
BAL.0183.0 • 2018-08-08
1
2 Engraved number for the wire diameter
6 Commissioning
2
EN - 11