Cooling Stage; End Of Welding; Troubleshooting; Service And Maintenance - Hürner EasyWeld 110 Manuel Utilisateur

H Ü R N E R S c h w e i s s t e c h n i k G m b H
Nieder-Ohmener Str. 26
35325 Mücke, Germany
The force increase, to reach the jointing force, must not
take longer than indicated in the appendix.
5.7

Cooling Stage

When the jointing force is reached, keep the movable car-
riage of the machine at this position, in order for this force
to be kept. It must continue to be applied, while the joint
cools down, for as many minutes as indicated in the tables
in the appendix. Like all other durations, it depends on the
wall thickness.
During this stage, no external forces must affect the new
joint.
5.8

End of Welding

After the full duration for the cooling stage, before open-
ing the clamps and taking the new joint out of them, reduce
the applied force to 0..
6

Troubleshooting

Issue
The electrical facing tool
does not operate.
or
The heating element
does not operate
The facing process does
not yield an outcome
of the desired/required
quality.
7

Service and Maintenance

• Clean the machine completely at the end of every job,
especially if it is going to be stored for a prolonged pe-
riod of time.
• Check that the shaft along which the movable parts
move is always clean.
• Check the clamps and their tightening mechanism for
proper operation.
• Check the PTFE coating of the heating element. Its sur-
faces should be homogeneous and without scratches. If
the material homogeneity is compromised or the part is
damaged, it should be replaced.
• Check the facing tool for proper condition, in partic-
ular the blades must be sharp. The blades can be re-
Version February 2022
Correction
The facing tool/heating el-
ement must be connected
to a power supply, and the
supply must meet the re-
quirements posed by it.
The facing blades must
be sharp and the rotating
blade supports, in a good
condition.
HÜRNER EasyWeld 110 (T) User's Manual
13
EN