Bowa ErgoLAP MONOPOLAR Mode D'emploi page 33

3.5.1. Inspecting parts
MN030-616-S1 EN
A Jaw
A1  Jaw OPEN/CLOSE
A2  Check straightness.
A3  Check condition of ball
(distortion, fracture, or similar).

Check jaw function.

Discard or replace defective
devices.
B Shaft tube
 Check Check the insulation
visually for possible
damage.
 Discard or replace
defective devices.
C Handle
 Install C1
 Check:
•
Do C1, C2, C3 move
freely?
 Discard or replace
defective devices.
D HF cable
 Check insulation visually.
Dispose of HF cables with
worn or faulty insulation.
13