Stadler Form Mixer Three Mode D'emploi page 25

Recommends to wash the mixing bowl, splashguard, beater, Scrapema-
ster™ spatula beater, whisk and dough hook in warm soapy water and wipe
dry – use a brush if necessary to remove any sticky food particles.
All plastic components deteriorate through prolonged dishwasher use. Ho-
wever, parts of are tolerant to dishwasher use. These include the stainless steel
mixing bowl, beater, Scrapemaster™ spatula beater, whisk and dough hook.
Note: Place only on the top rack of the dishwasher.
Stainless steel whisk
After washing the stainless steel whisk, the outer wire may have moved out
of position and become misaligned (see Figure 9). Please clip the outer wire
back into position (see Figure 10).
Maintenance Service
Bench Mixer should be regularly checked. After approximately four years
of domestic use, the grease in the gear compartment should be examined.
Storage
Keep Mixer in a convenient position on your kitchen bench ready for use at
all times. Place the beater, Scrapemaster™ spatula beater, whisk and dough
hook in the mixing bowl as storage of these attachments in a drawer with
other kitchen equipment may cause damage.
NOTE
Never wind the power cord around the mixer after use as the warmth from
the motor may cause damage to the power cord. For added convenience
the unused cord length can easily be pushed into the base of the mixer
for storage.
TROUBLESHOOTING GUIDE
Problem Possible Cause
Motor will not Motor is over-heated.
start.
Mixer head is not
locked down properly.
Motor is over- Use of a high speed for
heated. a long time.
Mixture too heavy.
Mixing quantity too
large.
Mixer head Thick mixture is pre-
does not lock venting the attachment
down properly. from going all the way
down into the bowl.
What to do
Unplug and allow motor to
cool, (the mixer head should
be cool to touch).
Move mixture in mixing bowl
to the side of the attachment,
to allow the attachment to go
all the way into the bowl.
Unplug and allow motor to
cool, (the mixer head should
be cool to touch).
Try mixing in batches.
Move mixture in mixing bowl
to the side of the attachment,
to allow the attachment to go
all the way into the bowl.
Problem Possible Cause
Attachment Attachment is not
is hitting the inserted correctly.
bowl.
Mixing bowl is not
locked into the base
properly.
Mixer is moving Chosen speed is too
on the bench- high for the mixture.
top. Mixture caught up in
the attachment.
Flour or spills on bench
top.
Cannot use or '+' button, '-' button
set the timer, or Pause/Start button
but the motor was depressed when
will start when the unit was switched
the speed dial on.
is being turned.
SPECIFICATIONS
Power: 1000 W
Voltage: 220–240 V / 50 Hz
Measurement: 380 x 215 x 350 mm
Weight: ca. 9,5 kg
The manufacturer retains the right to make changes in the technical specifi-
cations, inventory and design of this model without prior notice.
What to do
Remove the attachment and
try inserting again. Refer to
the instructions in this book-
let if needed.
Lock bowl into position. Refer
to the instructions in this
booklet if needed.
Lower the speed or mix in
batches.
Scrape down the attachment
and continue mixing.
Clean and dry benchtop as
well as the mixer base.
Unplug from the power outlet
for 5-10 seconds, then plug in
again ensuring no buttons are
pressed.
If this problem persists, there
may be food particles or
liquid in the switch. The unit
is safe to use in this mode,
however it is recommended
to take the product to an au-
thorised service centre.