Stihl MSA 120 C Notice D'emploi page 44

English
► If the tree begins to fall too soon: Abandon
the felling cut and retreat along the escape
path.
■ Kickback can occur if the rotating chain in the
upper quadrant of the bar nose makes contact
with a hard felling wedge and is suddenly
braked. There is a risk of serious or fatal
injury.
► Use aluminum or plastic felling wedges.
■ If the tree does not fall all the way to the
ground or gets caught on another tree, the
operator cannot finish the operation in a con‐
trolled manner.
► Stop the felling operation and use a cable
winch or suitable vehicle to pull the tree to
the ground.
4.8 Reactive Forces
4.8.1 Kickback
Kickback can be caused for the following rea‐
sons:
– The rotating saw chain in the upper quadrant
of the bar nose makes contact with a hard
object and is suddenly braked.
– The rotating saw chain is pinched at the bar
nose.
The chain brake cannot prevent kickback.
WARNING
If kickback occurs, the saw can be thrown up
■
in the direction of the operator. The operator
can lose control of the saw and be seriously or
fatally injured.
► Hold the saw firmly with both hands.
► Always keep your body out of the plane of
the cutting attachment.
44
► Operate the saw as described in this
instruction manual.
► Do not cut with the upper quadrant of the
bar nose.
► Always cut with a properly sharpened and
tensioned saw chain.
► Use a reduced kickback saw chain.
► Use a guide bar with a narrow radius nose.
► Always cut with the chain running at full
speed.
4.8.2 Pull-in
The saw is pulled away from the operator when
the bottom of the bar is used for cutting.
WARNING
■ If the rotating chain makes contact with a hard
object and is suddenly pinched, the saw is
abruptly jerked away from the operator. The
operator can lose control of the saw and be
seriously or fatally injured.
► Hold the saw firmly with both hands.
► Operate the saw as described in this
instruction manual.
► Keep the guide bar straight in the cut.
► Apply the spiked bumper properly.
► Always cut with the chain running at full
speed.
4.8.3 Pushback
The saw is pushed back toward the operator
when the top of the bar is used for cutting.
WARNING
■ If the rotating chain makes contact with a hard
object and is suddenly pinched, the saw can
4 Safety Precautions
0458-716-9621-E