Switch On Browser-Based Review Clients; Use Standby Mode At The End Of Each Day - Optos California P200DTx rg Manuel D'utilisation

Chapter 3 - How to...
1. Remove the scan head fabric cover.
2. Check the image server is switched
3. Switch
the scan head.
ON
If the scan head is in standby mode the status indicator will be blue. Press the blue status
l
indicator to switch
If the scan head has been shut down the status indicator will be
l
on the back of the scan head to the
device starts up.
The status lights on the front of the scan head cover will flicker and then settle on the green
l
light.
The touch screen powers up.
l
4. Wait for the scan head to start up. The following happens during start up:
The scan head takes less than five minutes to start up.
l
The system will run a series of self-tests during this time.
l
The status indicator will be white while the self-tests are running.
l
The imaging procedures will be available when the self-tests have completed and the status
l
indicator is green.
5. Enter your username and password on the touch screen when prompted. Usernames and passwords
are assigned by your System Administrator, see Managing user details on page 43 (all passwords are
case sensitive).
Note
If there is a network error when starting the scan head it is likely that there is a temporary problem
l
with the image server. You can attempt to clear problems by restarting the image server, see How
do I restart the image server? on page 53 .
You will be unable to capture images if the self-tests have
l
scan head. If the problem persists please contact your Optos representative, see Contact us on
page 63 .

3.1.1.3 Switch on browser-based review clients

Captured images can be reviewed using the
access the patient details and images stored on the system.
Browser-based review clients have to be on the same network as the scan head and the image server. Usually,
browser-based review clients have been logged off at the end of each day. To login to a browser-based review
client:
1. Press
[Ctrl]+[Alt]+[Del]
2. Type your username and password. Select
3. Connect to the
OptosAdvance
4. Enter your username and password when prompted. Usernames and passwords are assigned by your
System Administrator, see Managing user details on page 43 (all passwords are case sensitive).

3.1.2 Use standby mode at the end of each day

The scan head be put into standby mode at the end of each working day.
MUST
Note
You should follow the correct procedure in order to protect the integrity of the information on the disk
l
drives.
You should back-up your image server data at least once a week.
l
Page 30 of 69
English
and fully started up before switching
ON
the scan head.
ON
( ) position. There will be a short delay while the
ON
OptosAdvance
to display the Unlock Computer
OK .
URL from your browser.
ON
OFF
been successful. Please restart the
NOT
software. You need to login to
dialog box.
Copyright 2017, Optos plc. All rights reserved.
the scan head.
. Press the power switch
OptosAdvance to
Part Number: G108025/4GWE