salmson SIE Installation Et Mise En Service page 94

English
No. Designation
5.7.2.0 Pressure value cor-
rection
5.7.6.0 SBM function
5.7.7.0 Factory setting
6.0.0.0 Error acknowl-
edgement
7.0.0.0 Access disable
88
Type Symbol Values/explanations
Display orientation
±
When pressure value correction
is enabled, the differential pres-
sure deviation measured by the
differential pressure sensor that
is factory-fitted on the pump
flange is taken into account and
corrected.
Pressure value correction Off
Pressure value correction On
±
Setting for behaviour of signals
SBM run signal
SBM readiness signal
SBM mains On signal
±
OFF (default setting)
Settings are not changed by
confirming.
ON
Confirming will reset the set-
tings to factory settings.
CAUTION!
All manual settings will be lost.
±
For additional information, see
Section 11.3 "Acknowledging
errors" on page 99.
±
"Access disable" inactive
(changes possible)
(for further information, see
8.6.7 "Activating/deactivating
access disable" on page 82)
"Access disable" active (no
changes possible)
(for further information, see
8.6.7 "Activating/deactivating
access disable" on page 82)
Display conditions
Only displayed in Δp-c mode.
Is not displayed for all pump
variants.
Is not displayed when access
disable active.
Is not displayed when build-
ing management system
active
Is not displayed when access
disable active.
Is not displayed when build-
ing management system
active
Only displayed if an error is
present
Pompes Salmson 04/2012