Menu Elements Reference - salmson SIE Installation Et Mise En Service

8.7

Menu elements reference

No. Designation
1.0.0.0 Setpoint
2.0.0.0 Control mode
3.0.0.0 Pump on/off
4.0.0.0 Information
4.1.0.0 Actual values
4.1.1.0 Actual values sen-
sor (IN1)
4.1.2.0 Switching fre-
quency
4.1.3.0 Output
4.2.0.0 Operating data
Installation and operating instructions SIE-DIE-PBE
The following table gives an overview of the available elements of all
menu levels. The menu number and the element type are designated
separately, and the function of the element is explained. If applicable,
there is information about the setting options of the individual ele-
ments.
NOTE
A few elements are hidden under certain conditions and are therefore
skipped in the menu navigation.
If, for example, the external setpoint adjustment under menu number
<5.4.1.0> is set to "OFF", the number <5.4.2.0> will be hidden. Menu
number <5.4.2.0> will only be visible if menu number <5.4.1.0> has
been set to "ON".
The condition for hiding a menu element is explained in the last col-
umn of the table.
Type Symbol Values/explanations
±
Setting/display of the setpoint
(for further information, see
Section 8.6.1 "Adjusting the set-
point" on page 79)
±
Setting/display of the control
mode
(for further information, see
Sections 9.4 "Setting the control
mode" on page 91 and 6.3 "Con-
trol modes" on page 62)
Constant speed control
Constant Δp-c control
Variable Δp-v control
PID control
±
ON
Pump switched on
OFF
Pump switched off
Information menus
Display of current actual values
Depending on current control
mode
Δp-c, Δp-v: Value H in m
PID control: Value in %
HIGH
High switching frequency
(factory setting)
LOW
Low switching frequency
Current power input P
Display of operating data
Display conditions
Not displayed for manual
control mode
in W
1
The operating data refer to
the module currently being
operated
English
83