Wiring - SOMFY Orea WT Notice Originale

The wheel must be prevented from moving back and forth inside the winding tube:
2)
‡ Either by securing the winding tube to the wheel
using 4 Ø 5 mm Parker screws or 4 Ø 4.8 mm steel
pop rivets located between 5 mm and 15 mm from
the outside edge of the wheel, irrespective of the
type of winding tube.
1
The screws or pop rivets must only be fastened on
the wheel and not on the drive.
‡ Or by using a wheel lock, for non-smooth tubes.
Fit the tube end into the winding tube.
3)
2. 1. 4. Mounting the tube-drive assembly
2. 1. 4. 1. Star head drive
Fit the tube-drive assembly to the end support (F).
1)
Fit the tube-drive assembly to the drive support (G).
2)
Depending on the type of support, position the
retaining ring (H  )RU GULYHV •  1P ZLWK D UHWDLQLQJ
ring, a lockable retaining ring (I) must be used).
2. 1. 4. 2. Round head drive
Fit the support to the drive head, and then the
1)
removable side plate.
Slide the tube-drive-removable side plate assembly
2)
into the head rail.

2. 2. WIRING

Cables routed through a metal internal wall must be
protected and insulated by sleeving or sheathing.
Secure the cables to prevent any contact with moving
parts.
,I WKH GULYH LV XVHG RXWGRRUV DQG LI WKH SRZHU VXSSO\ FDEOH LV RI WKH +99) W\SH UXQ WKH
FDEOH LQ D 89UHVLVWDQW GXFW HJ WUXQNLQJ
7KH GULYH FDEOH FDQ EH UHPRYHG ,I LW EHFRPHV GDPDJHG UHSODFH LW ZLWK DQ LGHQWLFDO
cable.
1
Leave the drive power supply cable accessible: it must be easily replaceable.
1
Always make a loop in the power supply cable to
prevent water from entering the drive!
Switch the power supply off.
-
Connect the drive according to the information provided
-
in the table below:
Neutral
(N)
230 V 50 Hz
Blue
Copyright © 2005 - 2014 Somfy SAS. All rights reserved.
Cable
Live Live
Earth ( )
(L1) (L2)
Brown Black Green-yellow
2)
3)
1)
F
1)
2)
OFF
N L1 L2
230 V 50 Hz
Non contractual images
EN
15 mm
5 mm
L1
2)
G
H
I
L ≤ 50 m
35