Wiring - SOMFY Sunea 40 RTS DC Notice

EN
2.1.4.Installing the drive-tube assembly
CAUTION
The motorised product must not be compressed between the brackets.
1] If necessary, screw the bracket adapter to the drive head (f).
2] Assemble and fix the drive-tube assembly onto the end bracket (g) and onto
the drive bracket (h).
CAUTION
Ensure that the drive-tube assembly is secured onto the end bracket. This operation prevents the tube-drive
assembly from coming out of the end bracket attachment.

2.2.Wiring

WARNING
To ensure electrical safety, this Class III drive must be powered by a «SELV» voltage source (Safety Extra Low
Voltage).
PRECAUTION
• Cables routed through a metal wall must be protected and insulated by sleeving or sheathing.
• Secure the cables to prevent any contact with moving parts.
• If the drive is used outdoors and if the power supply cable is of the H05-VVF type, run the cable in a UV-resistant
duct, e.g. trunking.
• The drive cable cannot be removed. If it is damaged, return the drive to the After-Sales department.
CAUTION
• The cable between the drive and the power supply must not exceed 2,5 m (with wire cross-section min. 0.75mm²).
• Leave the drive power supply cable accessible: the product must be easily replaceable.
• Always make a loop in the power supply cable to prevent water from entering the drive.
2.2.1.Wiring with connectors
1] Wire the 4-pin drive connector (i) to the 4-pin
cable Y connector (j).
2] Wire the 2-pin cable Y connector (k) to the 2-pin
battery connector (m).
3] Wire the 4-pin cable Y connector (o) to the 2-pin
solar panel connector (p).
6
5113030C_Sunea 40 RTS DC.pdf 6
1]
f
2]
o
i j
©
Copyright 2020 SOMFY ACTIVITES SA. All rights reserved.
Sunea 40 RTS DC
h
g
p
k m
10/19/2020 5:49:32 PM