Motor/Tube Assembly; Installing The Tube/Motor Assembly; Wiring - SOMFY Pergola io Notice

3.3. Motor/tube assembly

1) Slide the
For smooth roller tubes, position the notch previously cut
on the crown.
2) For safety reasons, fix the roller tube to the drive wheel
with 4 x Ø 5 mm self-tapping screws or 4 x Ø 4.8 mm
steel pop rivets located:
- at least 5 mm from the outer rim of the drive wheel:
L1 - 5, and
- no more than 15 mm from the outer rim of the drive
wheel: L1 - 15.
The screws or pop rivets must only be attached to the
drive wheel and not to the motor.

3.4. Installing the tube/motor assembly

1) Fit the tube/motor assembly to the end bracket (C).
2) Fit the tube/motor assembly to the motor bracket (D).
3) Depending on the type of bracket, position the retaining ring
(E) (for motors ≥ 85 Nm with a retaining ring, it is essential
to use the locking retaining ring (F)).

4. WIRING

- Cut off the mains power supply.
- Connect the motor according to the information in the
table below:
230 V ~ 50 Hz
1 Brown
2 Blue
3 Yellow/Green
Copyright © 2010-2022 Somfy Activités SA,Société Anonyme. All rights reserved.
5069577C107-Pergola_io.indb 45 5069577C107-Pergola_io.indb 45
motor into the roller
Motor cable
Live (P)
Neutral (N)
Earth ( )
1
tube.
2 15 mm
1
2
D
3
E
OFF
1
230 V
2
~
3
50 Hz
3 x 1.5 mm 2
1
2
3
Pergola io
5 mm
L1
20 mm
C
F
3 x 0.75 mm 2
45
18/05/2022 18:46:25 18/05/2022 18:46:25