Publicité
Les langues disponibles
Les langues disponibles
12.4 Electrical lock output (you can have this option only by using an additional R1 card)
It is possible to connect the electrical lock directly on the control unit. A normally open contact is available on the output of the electrical lock for its acti-
vation. The contact closes when an opening impulse is given.
12.5 Courtesy Light
The output for the courtesy light is supplied with the control unit. It is possible to light up the operation area of the automatism during each motion by
connecting a charge of 230 Vac 100W MAX. The turning off is timed 1 minute after the stop of the automatism or until the end of its automatic re-
closing (if enabled). During the photocells test (if enabled) the courtesy light blinks shortly.
12.6 Diagnosis of radio signal
The control unit is equipped with a led for the diagnosis of the radio: the installer can immediately find if there are radio troubles which influence nega-
tively the correct functioning of the device.
•
Led turned off = no troubles
•
Led flashing = light troubles
•
Led turned on permanently = heavy troubles
6-1622158 REV.03
25/09/2020
ITA
ENG
FRA
ESP
DEU
POR
13 / 16
Publicité
