Allmatic B1EE ERMES2 Guide D'installation page 26

9. Learning the pedestrian opening
This procedure must be carried out ONLY by the installer and ONLY during the installation of the system. Always bring the gate to a totally closed
position before making any changements for a correct programming.
METHOD 1
Learn the second button of a
1
remote control already learned
Press and keep pressed the
2
MODE button on the card
Press and release the SEL button
3
on the card
Release the MODE button
4
The learning is cancelled if a safety device (photocell, edge, stop) is activated during the learning phase
Follow these instructions once entered the movement learning:
Give a pedestrian impulse by the button or
5
with a remote control (second key learned).
When the automation reaches the desired
pedestrian opening position, then press and let
6
go the wired PEDESTRIAN button or the
remote control key.
Give a pedestrian impulse by button or with a
7
remote control (second key learned).
NOTE: You need to learn the second key of a 2 or 4 keys already learned transmitter in order to command the pedestrian opening. After the RESET of
the memory, the pedestrian opening position is brought back to the default value.
METHOD 2
Learn the second button of an already
1
learned remote control
Give a pedestrian impulse with the 2nd button
2
just learned .
When the automatism's reaches the desired
pedestrian opening position, then you must
3
activate the OPENING limit switch.
Give a step by step command for closing the
4
automation.
NOTE: You need to learn the second key of a 2 or 4 keys already learned transmitter in order to command the pedestrian opening. After the RESET of
the memory, the pedestrian opening position is brought back to the default value, that a the completely open automation.
6-1622158 REV.03 25/09/2020
The accessing to the automatism's motion learning menu is shown by 1
Blink emitted by the flashing light
The automation starts to open
The automation stops.
The automation closes
The automation starts to open
The automation stops.
The automation closes
ITA ENG FRA ESP DEU POR
10 / 16