Allmatic B1EE ERMES2 Guide D'installation page 22

6. Torque adjustment
This procedure needs to be carried out ONLY by the installer and ONLY during the installation of the system. Always bring the gate to a totally closed
position before making any changements for a correct programming. The torque is fix during the slowdowns and does not depend on the position of
the "POWER" trimmer.
Repeat the measure of
the torque
Check the torque thrust by using a
dynamometer when the gate is in motion
Repeat the measure-
ment of the torque
We recommend to adjust the torque before carrying out the learning of the automatism working times
7. Learning the strokes
7.1 For applications of motors with and without limit switches (DIP 7 on OFF)
This procedure must be carried out ONLY by the installer and ONLY during the installation of the system. Always bring the gate to a totally closed
position before making any changements for a correct programming. During the learning phase you must decide if and where the gate needs to start
the slowdown phase.
Dipswitch Position
ON
1
OFF
7
Press and keep pressed the
2
MODE button on the card
Press and release the SEL button
3
on the card
4 Release the MODE button
The learning is cancelled if a safety device (photocell, edge, stop) is activated during the learning phase
Follow these instructions once entered the motion's learning:
Give an impulse of step-by-step through the button or
5
the transmitter
When the automation reaches the point where the
opening slowdown is desired, then press and release
6
the SEL (or MODE) button or give a step-by-step
impulse
When the automation reaches the point where the
opening is desired, then press and release the SEL
(or MODE) button or give a step-by-step impulse
7
The automatism
opening limit switch is installed
Give an impulse of step-by-step through the button or
8
the transmitter
When the automatism reaches the point where the
closing slowdown is desired, then press and release
9
the SEL (or MODE) button or give a step-by-step
impulse
When the automatism reaches the point where the
closing is desired, then press and release the SEL (or
MODE) button or give a step-by-step impulse.
10
The automatism stops automatically if the closing
limit switch is installed
11 The control unit blinks 3 times
6-1622158 REV.03 25/09/2020
It is possible to turn the trimmer POWER to the
direction of the "+" to increase the torque.
The torque is too low
The torque is too high
It is possible to turn the trimmer POWER to
the direction of the "-" to reduce the torque.
Place the DIPSWITCH 7 on OFF
stops automatically if the
ITA
The accessing to the automatism motion learning menu is shown by 1
Blink emitted by the flashing light
The automation starts to open
The automation works with a reduced speed.
The automation stops.
The automation starts to close
The automation works with a reduced speed.
The automation stops.
The learning is finished
ENG FRA ESP DEU POR
POWER
-
+
POWER
-
+
6 / 16