Télécharger Imprimer la page

Allmatic B1EE ERMES2 Guide D'installation page 20

Publicité

Les langues disponibles

Les langues disponibles

4. Learnings
4.1 Transmitter's learning
The learning of each transmitter must always be done when the automatism is closed.
CLOSE THE
GATE / DOOR
Press and release the first button of the remote
control. The light blinks twice.
The first button is memorized. Press
A
and release the MODE button. The
flashing light led turns on fix.
Press and release the second button of the
remote control. The flashing light blinks once.
The two buttons are memorized and the
procedure is finished. The procedure must
be repeated from point A if you want to learn
also the MODE and SEL buttons.
4.2 With the hidden key of a transmitter already learned (only for rolling code B.RO models)
With the automation closed, help you with a little clip to press the hidden button of a previously learned transmitter. The start of learning is signaled by the turn-
ing on of the flashing light. Push the button of the transmitter which you want to memorize, then the light flashes once (twice if the code is new, once if the code
was already learned). The control unit returns to its normal working and the new transmitter can run the motor.
6-1622158 REV.03
25/09/2020
Press and release the MODE
button. The flashing light led
turns on fix.
YES
YES
YES
YES
ITA
ENG
Verify that the gate is closed (led LS.CL is turned off) and check that
the radio module is correctly connected. If the problem persists, then
NO
carry out the preliminary checks described at chapter 8.
If the flashing light has flashed only once, then the pressed button
was already learned and the procedure can go on. Otherwise check
that the remote control works; it must have the same decoding set
NO
into the control unit, and that the radio module must be connected.
Now repeat the test.
Check that the gate is closed and
NO
check that the radio module is
connected properly.
Verify that the remote control works; it must have the
same decoding set into the control unit, and the radio
NO
module must be connected properly. Now repeat the test.
Pedestrian
SS
SEL
MODE
FRA
ESP
DEU
POR
4 / 16

Publicité

loading