Positioning And Handling - MBM FRG74A Manuel D'installation Et D'utilisation

not suitable for the purpose.
RESIDUAL RISK OF FIRE /
This risk exists by flammable
liquids / material flammable
OPERATIONAL MODE FOR A
SMELL OF GAS IN THE ENVI-
RONMENT - see SECT. IMA-
GES - REF. a).
If there is a smell of gas in
the environment, it is man-
datory to urgently imple-
ment the procedures described
below.
Before proceeding with the ope-
rations, see "General safety infor-
mation".
OBLIGATIONS - PROHIBITIONS -
ADVICE
Upon receipt, open the machine
packaging and ensure that the
machine and accessories have
not been damaged during transporta-
tion. Where this is found to be the
case, notify the carrier immediately
and do not proceed with installation
but contact the qualified and author-
ised personnel.
The manufacturer is not liable for
damage caused during transportation.
HANDLING SAFETY /
Failure to follow the instructions re-
ported below could result in expo-
sure to the risk of serious injury.
The operator authorised for the
handling and installation opera-
tions of the appliance must pre-
pare, if necessary, a "safety plan" in or-
THE PRESENT MANUAL IS PROPERTY OF THE MANUFACTURER. ANY REPRODUCTION, EVEN PARTIAL, IS PROHIBITED.
GENERAL AND SAFETY INFORMATION

POSITIONING AND HANDLING

- 8 -
Immediately stop the gas supply
•
(Close the network tap, detail A).
Ventilate the room immediately.
•
Do not operate any electrical de-
•
vice in the environment (Detail
B-C-D).
Do not operate any device which
•
could produce sparks or flames
(Detail B-C-D).
Use a means of communication
•
that is external to the environ-
ment where there is a smell of
gas to warn the relevant enti-
ties (electricity operator and/or
fire-fighters).
der to ensure the safety of the persons
involved in the operations. In addition,
they must follow and strictly and scrupu-
lously implement the laws and regula-
tions relating to mobile sites.
Ensure that the lifting means
adopted have capacity that is
adequate for the loads to be lifted and
are in a good state of maintenance.
Perform the handling operations
using lifting means with a capa-
city appropriate to the weight of
the appliance increased by 20%.
Follow the directions on the
packaging and/or on the same
appliance before handling.
Check the centre of gravity of the
load before lifting the appliance.
Lift the appliance to a minimum
height from the ground in order to
ensure its handling.
Do not stand or pass under the ap-
3.