Positioning And Handling; Disposal Of Packaging - MBM FRBE74T Manuel D'installation Et D'utilisation

containing substances which risk
exploding;
• using food in closed containers
(such as jars and cans), if they are
not suitable for the purpose.
RESIDUAL RISK OF FIRE /
This risk exists by flammable
liquids / material flammable.
Before proceeding with the ope-
rations, see "General safety infor-
mation".
OBLIGATIONS - PROHIBITIONS -
ADVICE
Upon receipt, open the machine
packaging and ensure that the
machine and accessories have
not been damaged during transporta-
tion. Where this is found to be the
case, notify the carrier immediately
and do not proceed with installation
but contact the qualified and author-
ised personnel.
The manufacturer is not liable for
damage caused during transportation.
HANDLING SAFETY /
Failure to follow the instructions re-
ported below could result in expo-
sure to the risk of serious injury.
The operator authorised for the
handling and installation opera-
tions of the appliance must pre-
pare, if necessary, a "safety plan" in or-
der to ensure the safety of the persons
involved in the operations. In addition,
they must follow and strictly and scrupu-
lously implement the laws and regula-
tions relating to mobile sites.
Ensure that the lifting means
adopted have capacity that is
adequate for the loads to be lifted and
are in a good state of maintenance.
Perform the handling operations
using lifting means with a capa-
city appropriate to the weight of
THE PRESENT MANUAL IS PROPERTY OF THE MANUFACTURER. ANY REPRODUCTION, EVEN PARTIAL, IS PROHIBITED.

POSITIONING AND HANDLING

the appliance increased by 20%.
Follow the directions on the
packaging and/or on the same
appliance before handling.
Check the centre of gravity of the
load before lifting the appliance.
Lift the appliance to a minimum
height from the ground in order to
ensure its handling.
Do not stand or pass under the ap-
pliance during lifting and handling.
HANDLING - TRANSPORTATION /
- see SECT. IMAGES - REF. a).
The orientation of the packed
appliance must be maintained
according to the instructions
given by the pictograms and lette-
ring on the outer packaging.
Position the lifting means paying at-
1.
tention to the centre of gravity of the
load to be lifted (detail B-C).
Lift the appliance enough to move it.
2.
Place the appliance on the site cho-
3.
sen for final positioning.
STORAGE / The storage methods of
the materials must include pallets, con-
tainers, conveyors, vehicles, tools and
lifting devices that are suitable to pre-
vent damage due to vibration, impact,
abrasion, corrosion, temperature or oth-
er conditions that might arise. The parts
stored should be periodically checked
to detect possible deterioration.

DISPOSAL OF PACKAGING

Disposal of the packing materials
is the responsibility of the reci-
pient that should proceed in ac-
cordance with the laws in force in the
country of installation of the appliance.
1. Remove in sequence the upper and
lower corner protectors;
- 8 -
3.